Recording The Radio; Tape-To-Tape Recording - Technics SC-DV290 Operating Instructions Manual

A
´
2
REC
PAUSE
3
B
1
DECK 1/2
2
TAPE EDIT
3 2
º
TUNED
MHz
1 2
º
º

Recording the radio

A
Preparation: Do the preparatory steps (
1
Tune to the required station.
( page 27, 28)
2
Press [ REC PAUSE].
The deck goes into the recording standby mode and the play indicator
" " or " " starts flashing.
3
Press [ ]
recording.
To stop recording
Press [ ].
To temporarily stop recording
Press [ REC PAUSE].
The deck goes into recording standby mode.
To resume recording press [ ] or [ ] with the flashing indicator.
ë
NR

Tape-to-tape recording

B
2
REC
Preparation:
Do preparatory steps 1 and 3 (
Insert the tape to be recorded in deck 1.
1
Set the tape direction on both decks.
Press [DECK 1/2] to select "DECK 2".
First press [ ] or [ ], and then [ ].
Repeat steps
2
Press [TAPE EDIT] to start recording.
The indicator " " or " " shows deck 2 direction.
If either deck 1 or deck 2 stops, the other deck also stops.
To stop recording
Press [ ].
Both decks stop.
To enjoy another source while recording
Start playing the other source.
You can change the volume level and tone quality without affecting the re-
cording.
Note
The recording level and the noise reduction effect of the original (playback)
tape will be recorded on the new tape.
ë
NR
2
REC
page 35).
or [ ]
(reverse side) (forward side)
page 35).
and for deck 1.
to start
37