Sequential Playback Between 2 Tapes - Technics SC-CH717 Operating Instructions Manual

_i_!::i:!_!ii_i_!_ii!_!_i_i_i_i_iii_ii_iiii_iiiiiiiiiiiii_iii_i_i_i;i_iii_ii_i_!_iiiii_!_ii_iiiii_i_iiiiiiiii_ii_i_i_i_iii_ii_i_i_i_i_i_i_i_i_i_i_ii_ii_i_i_i_iiiiiii_ii_ii_iiiiiiiiiiiiii_iiii_iiiiiiiiiiiii_iiiiiii_iiiiiiiiii_iii_ii_iiiii@iiiiiii_iiiii_iiii_ii_i_i _ _ii_iiiii_iiii_ii_iiii_iiii_i_ii!iii!iii_iiiiiiii_ii_iii_iiiiiiii@_iii_i_ii_i_i_iii_i_i_i_iii_iiiiii_i _'iiiii_iii@iii_i_iiiiiiiiiiiiiiiiii_ii_i_i_i_
i_i_i_i_i_i_i _: _/:_.1_ _ _ _%_;_;_i_ _;_iii_i_ _iiii!!_!i!_i_!!i_!!i!iiii!!_!i_!i_!!iii! !i!i!!i_ii!!i!i!ii i!!iiii!!i!!!!!!!!i!!!!!!!!!iiiii!!i!ii!!i!i!_!!! !i!i!i iiii_!!!i !ii!iii_i!i_iiiii_!_iii_iiii_i_i_iii _iii_i_i_i_ ii_i_i_i_i i_i_ii_i i_i_i_i_i_i _ii_i_i_i_i_ i_i_i_i_i_i _i_i_ii_ii_i_ i_iiii_i _i_i_ ii_i_i_i_i_i_ i_iiii_i_i ii_i_ii_iii ii iiiiiii_!iii iiiiii!!i!!!!i!i!i!iiiiiiii!i! iii_!!iiiiiiii_ii!!!iiiiii_iii_ii iii_i_i_i_i_i _ii_i_i_i_i_i_ ii_i_i_i_i_i_i_i_i_i_i_i_i_i_ i_i_i_i_i_i_i _i_i_ i_i_i_ii_i_i_i_i_i_i_i_i_ii_i_i_i_ ii!i_i!i !iiii_iiii!iiiiiiii_!iii !ii
Sequential playback between 2 tapes
You can listen to two tapes consecutively with the procedure below.
1 345 2 6 1
I
I "t..
/
(
,I,
[] l
_ _ Load cassettes in decks 1 and
2.
Load with the side that you wish to listen
to first facing you in deck 1.
2
Press CLOSE to close each
deck's cassette holder.
DOLBY NR
Press DOLBY NR if the cas-
sette you want to play was re-
corded using Dolby NR.
The DOLBY NR IN indicator will light up.
If the tape was not recorded using Dolby
NR, press DOLBY NR and the DOLBY
NR OUT indicator will light up.
REVERSE MODE
o o_o_
%
Press REVERSE MODE to set
to the c_._ mode.
-_O_-I-OECK-2© P ress DECK 1/2 to select
deck 1.
The DECK 1 indicator lights to show you
can select deck 1.
Press D to start playback.
Two tapes will play back as follows:
]
Forward side of tape in deck 1
/
f
Reverse side of tape in deck 1
f
Forward side of tape in deck 2
/
/
J Reverse side of tape in deck 2 I-_
J
After repeating above operation 8 times,
the tape will automatically stop.
L_i__J To stop sequential tape play:
Press [q.
For your reference:
oYou cannot select Dolby NR for deck 1 and deck 2 respectively.
eWe recommend that you use cassettes of the same type (Dolby
noise reduction) in both decks.
eYou can also start playback from a position other than the forward
side of the tape in deck 1.
About priority of the deck:
When you load cassettes in both decks, DECK 1 or 2 indicator will
light to show which deck you loaded last.
When you switch on the power, DECK 1 indicator will light.
28