Advertisement
NOTE: Stand behind
the tiller as if you were
going to operate it. Your
right hand corresponds
to the right side of the
tiller; your left hand
correspondsto the left
side of the tiller.
NOTE: This operator's
manual may cover
various models of tillers.
The units illustrated
may vary slightly from
your unit. Follow only
those instructions which
pertain to your model
number.
iMPORTANT
::Thisunit is shipped
without gasoline or oi
i in the engine. Fill up
i gasoline and oil as
instructed in the accom-
panying engine manual
i BEFORE operating your
machine.
Assembly
1. Removethe star handle knobs and carriage
boltsfrom the lower handle, Figure 3-1.
Figure3-1: Removehardwarefrom lowerhandle.
J
2. Position the upper handle onto the lower
handle, Step A Figure 3-2. Align the holes
on lower handle with the holes on the upper
handle (choose the upper or lower holes
depending on the desired handle height).
3. Insertcarriage bolts through the holes and se-
cure with star knobs, Step B Figure 3-2. Make
certain carriage bolts are seated securely into
one of the two positions provided.
f
4. Insert left end of tine clutch control into the
hole on the left side of the upper handle,
Figure 3-3.
f
\
Figure3-3: Installleft side ofthe tine clutchcontrol.
J
5. Insert the Z-fitting on the clutch cable into
the hole on the tine clutch control. Hook the
"Z" end into the opening from the inside to
the outside as shown in Figure3-4.
\
.......
J
Figure3-4: Hookcable into tine clutchcontrol.
'_
_j
Figure 3-2:Attachandsecure upper handle.
6
Advertisement
