Mitsubishi CS-40505 Owner's Manual page 52

Using the remote control (cont.)
If your cable box is
this brand...
Zenith
Hamlin
Jerrold
G.I.
Oak
Pioneer
S.A.
If your cable box is
...enter this code ...enter this code
this brand...
51 Tocom
52, 53, 69 Pa_.asonic
54, 57, 58, 59, 60, 85, 87 Macom
Philips 55,56
61,62,82
64,65,84
66,86,88,89,91,92
Regency
67,68,72
63,7O
71
?3,74,75,76,77,
93,94,95,96,97,98,99
79
_Important:
):Important:
_-,Important:
Sometimes manufacturers will change their products, or they may
use more than one code. If this is the case, your remote may not be
able to operate your VCR or cable box°
Each layer (CABLE, VCR-A or VCR-B) can be set for either a cable
box or a VCR.
When you replace the batteries in your remote control, the remote
will return to its initial setting.
<using your remote control to operate your VCR>
After you have set up your remote control for your particular brand
of VCR, you can use the remote to operate your VCR.
Choose the layer using a select button on the remote control:
CABLE, VCR-A, or VCR-B.
Point the remote control at the VCR and pre,_s the desired
buttons.
If you are using a Mitsubishi VCR, you will be able to use all of the
buttons on the remote control to operate your VCR except for
MUTE, VOLUME and the PIP hmction buttons.
If you are using another brand of VCR, you can use the POWER,
CHANNEL, REC, STOP, PAUSE, REW, PLAY and FF buttons to
operate your VCR.
50 Chapter 3 : Operating Your TV