Connect Drain Hose; Connect The Inlet Hoses; Remove Drain Hose From Washer Cabinet; Laundry Tub Drain Or Standpipe Drain - Maytag MTW5820TW0 Use & Care Manual

Table of Contents

Advertisement

Available languages

Available languages

CONNECT
DRAIN
HOSE
Proper connection
of tile drain
hose protects your floors from damage
clue to water leakage.
Read and follow
these instructions.
]he drain hose is connected
to your washer
and is stored
inside the washer
cabinet.
Remove drain hose from washer cabinet
Gently
pull the corrugated
drain
hose out of the washer
from the top of the hose. Continue
to
pull the hose until the end emerges.
Do not force excess drain
hose back into the rear of the
washer.
\
Laundry tub drain or standpipe
drain
Connecting the drain hose form to the corrugated drain hose
A. Drain hose reliefs
1.
Feed end of drain
hose into one end of form.
Place end of drain hose form into the drain
hose relief.
2.
Bend the hose over the top of the form and feed into the other end of the form.
To keep drain water from going back into the washer:
Do not force excess drain
hose into standpipe.
Hose should
be secure but loose enough
to provide
a gap for air.
Do not lay excess hose on the bottom
of the laundry
tub.
Floor drain
Do not install the drain
hose form on to the corrugated
drain
hose. You may need additional
parts. See Floor drain
under "lbols
and Parts."
CONNECT
THE INLET
HOSES
The washer
must be connected
to the water faucets
using new inlet hoses (not provided).
Do
not use old hoses.
Insert new flat washers
into each end of the inlet hoses. Firmly seat the washers
in the
couplings.
A
B
A. Coupling
B. Washer
Connect
the inlet
hoses to the water
faucets
Make sure tile washer
basket is empty.
1.
Attach hose to the hot water faucet. Screw on coupling
by hand until it is seated on the
washer.
2.
Attach hose to the cold water faucet.
Screw on coupling
by hand until it is seated on the
washer.
3.
Using pliers, tighten
the couplings
with an additional
two-thirds
turn.
lighten the couplings with an additional two-thirds turn.
NOTE: Do not overtighten
or use tape or sealants on the valve. [Damage to the valves can
result.
I

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents