Oven Whldow & Light - Maytag PGR5750LDS Use & Care Manual

i
Oven Door
Do not p!ace excessive weight On or stand on an open
oven d0or. This couM cause the range to tip over, break
the door, or injure the user.
Note: The oven door on a new range may fed "spongy"
when it is closed. This is normal and will decrease with use.
Oven Window
To protect the oven door window:
1. Do not use abrasive cleaning agents such as steel wool
scouring pads or powdered cleansers as they may scratch
the glass.
2. Do not hit the glass with pots, pans, furniture, toys, or other
objects.
3. Do not close the oven door until the oven racks are in
place.
Scratching, hitting, jarring or stressing the glass may weaken
its structure causing an increased risk of breakage at a later
date.
Leveling Legs
Be sure the antirtip bracket secures one of the rear
from accidentally tipping.
Electrical Connection
Appliances which require electrical
power are equipped with a three=
prong grounding plug which must be
plugged directly into a properly grounded
three-hole 120 volt electrical outlet.
A/ways disconnect power to appiiance before servicing.
The three-prong grounding plug offers protection against
shock hazards. DO NOT CUT OR REMOVE THE THIRD
GROUNDING PRONG FROM THE POWER CORD PLUG.
If an ungrounded, two-hole or other type electrical outlet is
encountered, it is the personal responsibility of the
appliance owner to have the outlet replaced with a
properly grounded three=hole electrical outlet.
Oven Light
. I
"
Make su[e bulb cover and bu b are cool before touching.
To assure the proper replacement bulb is used, order bulb from
Maytag. Caii 1-877-232-6771 USA and 1-800-688-8408 Canada
and ask for part number 74004458 - halogen bulb.
To replace oven light bulb:
1. Disconnect power to the range=
2. When oven is cool, use fingertips to grasp edge of bulb cover.
Puii out and remove.
3. Carefully remove old bulb by pulling straight out of ceramic
base.
4. To avoid damaging or decreasing the life of the new bulb, do
not touch the bulb with bare hands or fingers. Hold with a
cloth or paper towel. Push new bulb prongs straight into
small hobs of ceramic base.
5. Replace bulb cover by snapping into place.
6. Reconnect power to range. Reset clock.
19