Table of Contents
Advertisement
Save These Instructions
Appliances
with the (_) symbol on the data plate
have been listed with Underwriters'
Laboratories,
Inc. Those with a CSA Monogram
on the data
plate have been certified
by the CSA Testing
Laboratories
as complying
with Canadian
Standards Association
requirements.
Gas dryers
with an AGA symbol on the data plate have been
design certified with the American
Gas
Association;
those with a CGA symbol on the
data plate have been approved
by the Canadian
Gas Association.
Nevertheless,
as with any
equipment
using electricity
and having moving
parts, there are potential
hazards.
To use this
appliance
safely, the operator
should become
familiar with the instructions
for operation
of the
Appliance
and always exercise care when
using it.
EXHAUSTING
THE DRYER
A proper exhaust system is critical for good
drying results. Restricted airflow affects dryer
performance and results in longer drying times.
Exhaust ductwork guidelines:
•
Use 4" diameter
rigid metal exhaust duct. Do
not use smaller duct. Minimize
the length of
duct and the number of elbows.
Secure joints
with duct tape. Do not use screws.
• Never use plastic or nonmetal flexible duct. This
can kink, cause lint buildup and reduce airflow
which creates service problems.
•
If flexible duct must be used, use only the type
with a stiff sheet metal wall. Do not kink or
crush the duct. Do not use flexible duct with a
thin foil wall.
•
Clean out previously
used exhaust duct.
Replace kinked or crushed sections. Be sure
exhaust vent hood flap opens and closes freely.
*
Refer to the installation
instructions for
additional
dryer exhaust information.
ENERGY SAVING
TIPS
• Clean the lint filter after each cycle for greater
efficiency and performance.
• Avoid overloading the dryer. A proper wash
load is a proper dryer load. Do not combine
loads. Avoid drying very small loads or mixed
loads of heavy, hard-to-dry
items with
lightweight
ones.
•
Properly select and check exhaust venting. Four
inch rigid metal ducting is recommended
to
prevent lint collection
and improve dryer
operation.
Periodically
check the ductwork
for
any obstructions
that could reduce the airflow
and efficiency.
•
Remove items from the dryer as soon as
tumbling stops for best results and efficiency.
This reduces wrinkling
and ironing.
REVERSING
THE DOOR
The dryer door is designed
with flexibility
in mind.
It can be mounted on the dryer front so as to open
from left to right, or reversed and open from right
to left. This provides
flexibility
for the dryer located
in a cramped
area or for the person preferring
a
different
door swing.
Simply follow the steps as
listed.
1)
Remove hinge hole covers and cover from
latch. These will be re-used.
2)
Rest door on knee for support.
3)
Remove 4 screws holding
hinges to front
panel.
4)
Turn door upside down.
5)
Support on knee.
6)
Insert screw in the small round hole first and
start by hand.
7)
Tighten screw to position door.
8)
Insert top screw of other hinge and tighten.
9)
Insert and tighten remaining
screws.
10)
Replace hinge hole covers and door latch
cover in opposite
side.
HINGE HOLE
LATCH
COVER
PAGE 3
Hide quick links:
Advertisement
Table of Contents
