Table of Contents
Advertisement
Before turning on yourVCR, make sure there are batteries in the
remote control and theVCR and TV are connected correctly.
•
Follow the steps on this page only when you plug theVCR
power cord into the wall outlet for the first time.
• You may not be able to program channels at step 5 if you are
using a Cable Box.
i
Turn on the TV.
I
2
Turn the TV on. Set it to the 'same channel as the
CH31CH4 switch on the back of the VCR.
2
Press the POWER
button
to turn on theVCR.TheVCR
light and the PWR. light will appear on theVCR
display panel.The
language select display screen shown below will appear. (If it does
not appear, follow the steps on page 12 to program channels and
page 17 to select a language.)
ENGUSH
ON
ESPA_IOL
KE SELECTION OP,
SH MENU_
CONTINUE
i
3
4-
Within
60 seconds, press the Number
I button
to select
English on-screen
displays or the Number
2 button
to
select Spanish on-screen
displays.
4
_
(_
(_
G) G)
5-d5
@
dS-d5
PHILIPS
Press the MENU
button.
The channel program display shown
below will appear.The display will disappear after about 60 sec-
onds if you do not press any buttons.
CR
HEN
...
CH
UP KEY
RpI_Y ONLY - PUSH STOP
5
Press the CHANNEL
(Up)
button
to begin automatic
channel
programming.
AUTO
SET PROCEEDING
PLEASE
WAIT will appear on-screen.TheVCR
will place all of the channels
you receive into its memory, so when you scan through channels
using the CHANNEL
(Up/Down)
buttons, you'll only scan through
channels that you receive.When
all channels are programmed,
CHANNELS
ARE SET will appear on-screen
briefly.Then the TV
will go to the lowest channel programmed.
• To skip this feature and play a tape
immediately, insert a tape with its
record tab removed. Or, to skip step
3, press the MENU button.All on-
screen displays will be in English.To
skip step 5, press the STOPbutton.
Channels will not be programmed,
and CHANNELS NOT SET will
appear on-screen.
• If you try to program channels
when there is no antenna or cable
connected to the VCR,programming
will appear to take place, but even-
tually a NO TV SIGNALS message
will appear on-screen. Connect an
antenna or cable to the VCR and try
again. You may need to follow the
steps on page 12.
Advertisement
Table of Contents
