Playback Features - Magnavox VRT344 Owner's Manual

32
Playback Features
• •••••• • •lo•• •ao• • • ee• • 1•• ,• eee oe •e, o• •e Q • • ••e _e• • eQo • iIeeeo lee e•
Remote Control
The following playback features will always operate:
f,o,
@@_q2.
E3@@ _3
@@
o c::=D O
O0000
O0 00
POWER
Button
Automatic Playback
When you put a tape in the VCR, the power will come on automatically. If the
tape's record tab is missing, playback will begin.
Automatic Rewind, Eject Off
"
When a tape is played, fast forwarded, or recorded to its end, the VCR will
rewind the tape, enter Stop mode, and eject the tape. Then the VCR will turn
itself off.
Memory Rewind, Power Off
When the POWER button is pressed while the VCR is rewinding a tape, the
VCR will turn itself off when it has finished rewinding. REWIND _ POWER
OFF will appear on-screen.
Tape Eject.
A tape can be ejected with the VCR power on or off (but the VCR must be
plugged in). A tape cannot be ejected when a timer recording is programmed.
TRACKING Auto Tracking
(Up/Down)
The VCR has automatic tracking, which continually adjusts tracking to give
Buttons
you the best possible picture quality. With some recordings, however, you may
get a better picture using the manual tracking controls (see below).
Manual Tracking
To adjust the tracking manually, press the TRACKING (Up/Down) buttons on
the remote control.
NOTES."
• To return tracking to the position it was in when the VCR was shipped from
the factory, press at the same time the CHANNEL (Up/Down) buttons on the
VCR.
• Tracking is returned to auto tracking when a tape is inserted, or when the
STOP button is pressed to halt playback.
• The CHANNEL (Up/Down) buttons also adjust tracking when the VCR is in
Play mode.
• When the VCR is in Slow mode, auto tracking will not work. Instead, use the
TRACKING (Up/Down) buttons to reduce noise lines in slow motion play-
back.
• Manual tracking will not operate when the VCR is in Still mode. If you want
to reduce noise lines in a still picture, place the unit in Slow mode. _Jse the
TRACKING (Up/Down) buttons to remove the noise lines. Then return to
Still mode.