Table of Contents
Advertisement
27
Playback
Features
°o,°°°°°°°°
°o°
°°°
°°°°°°°°o°°°°
°
°°°°o°°°°°°,,°°°°°°o°
,°
°
°°°
°°°°°o
VCR
The following
playback
features will always operate:
CHANNEL
(Up/Down)
Buttons
Automatic
Playback
When you put a tape in the VCR, the power will come on automatically.
If the
tape's record tab is missing, playback will begin.
Automatic
Rewind, Eject, Off
When a tape is played, fast forwarded,
or recorded
to its end, the VCR will
rewind the tape, go into the Stop mode, eject the tape, then turn itself off.
If the time counter
memory
is set, the VCR will only rewind to the point at
which the counter
is set to zero, then stop.
The VCR will not eject the tape
automatically
or shut itself off.
Remote
Control
o
5_
4
5
6
C) C) C) if3
0
÷100
-- TRACKING
(Up/Down)
Buttons
Tape Eject
A tape can be ejected
with the VCR power on or off (but the VCR must be
plugged
in). If a Timer Recording
is programmed,
a tape can only be ejected
with the power on.
Auto Tracking
The VCR has automatic
tracking,
which continually
adjusts
tracking
to give
you the best possible
picture quality.
With some recordings,
however,
you may
get a better picture
using the manual
tracking
controls
(see below).
Manual Tracking
To adjust the tracking
manually,
press the TRACKING
(Up/Down)
buttons
on
the remote control.
NOTES."
•
To return tracking
to the position
it was in when the VCR was shipped from
the factory,
press the CHANNEL
(Up) and the CHANNEL
(Down)
buttons
on
the VCR at the same time.
•
Tracking
is returned
to auto tracking
when a tape is inserted,
or when the
STOP button is pressed
to halt playback.
• The CHANNEL
(Up/Down)
buttons
on the VCR also adjust tracking
when
the VCR is in Play mode.
• When the VCR is in Slow mode, auto tracking
will not work.
Instead,
use the
TRACKING
(Up/Down)
buttons
or the CHANNEL
(Up/Down)
buttons on the
VCR to reduce noise lines in slow motion playback.
• Manual tracking
will not operate
when the VCR is in Still mode.
If you want
to rt_duce noise lines in a still picture, place the VCR in Slaw nmde.
Use the
TRACKING
(Up/Down)
buttons
to remove
the noise lines.
Then return to
Still mode.
l|n|/
Advertisement
Table of Contents
