Table of Contents
Advertisement
ANTENNA CONNECTIONS
_]_1
D_ €.q_li I I/L_II_K5 i_[ILTO]l_ LIHU
1. Push the stem of the Dipole Antenna (accessory)
into the hole for antenna at the back of TV/VCR.
2. Connect the fiat twin-lead cable from the Dipole An-
tenna to the 300/75 ohm Matching Adapter (acces-
sory).
3. Plug the Matching
Adapter to ANT terminal of
TV/VCR as shown in drawing.
For the best reception, extend the Dipole Antenna and
adjust its length and position. (Avoid handling the top
section when making adjustments).
Dipole Antenna
(accessory)
Flat twin-lead Cable
==, @
I
Matching
|
Adapter
/
(accessory)
,'_ 0o0
"_" 0 0
1. Connect the 300-ohm flat twin-lead cable from an
outdoor UHF antenna to the VHF/UHF Combiner
(not supplied).
2. Connect a round type 75 ohm coaxial cable from an
outdoor VHF antenna to the VHF/UHF Combiner
(not supplied).
3. Plug the VHF/UHF combiner to ANT terminal of
TV/VCR as shown in drawing.
VHF AntennaUHFAntenna
Round type
75-ohm
Coaxial Cable
i rr_.J,
, ""6_" cUN;:=_
() _
I VHF/UHF Flat twin-lead
_* O°_)
I Cornbiner
Cable
(Not supplied)
NOTES:
1) If it is difficult to get good reception with the indoor
antenna, the use of an outdoor antenna is recom-
mended. Before an outdoor antenna is connected to
the set, the indoor antenna should be disconnected.
2) The optional combiner can be purchased from your
local retail electronics store. Consult a salesperson
for assistance.
A VHF UHF 75 ohm combination antenna can be con-
nected to ANT terminal.
VHF/UHF
Combination Antenna
_
Note to CATV system installer
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected
to the grounding system of the building as close to the point of cable entry as practical.
- !i -
EN
_r_r_-k-t_ 5BI0
Advertisement
Table of Contents
