KitchenAid Sculptura KUDS24SE Use & Care Manual page 24

CI÷ani d h w
If mineral deposits from hard water accumu-
late on the interior of your dishwasher, clean
with a damp cloth or follow the instructions
indicated in "Removing spots and film" on
page 28.
<_ Do not clean the dishwasher interior until it
has cooled.
Do not use any type of cleanser that may
cause foaming or sudsing. Use cleansers
made for stainless steel products.
,_'Run the dishwasher through a Normal
cycle with detergent after you are finished
cleaning the interior.
Wipe the control panel, front, and sides with
a damp cloth, then dry. Never use detergents
or abrasive cleansers which may damage
the finish.
Protect your dishwasher and water lines
against freezing if they are exposed to
freezing temperatures in a seasonal dwell-
ing. Refer to the Installation Instructions and
have a qualified person do the following:
Close the door.
Turn off electrical power supply to the
dishwasher.
3 Remove the 4 screws attaching access
panel and lower panel to dishwasher using
a V," hex socket, nut driver, or Phillips
screwdriver. Remove panels and set
panels aside on a protective surface.
._. Shut off the water supply. Place a pan
under the fill valve and disconnect at both
inlet and outlet sides. Drain water into pan.
_-_. Place a pan under the check valve outlet
and disconnect the flexible tubing at the
check valve. Drain the machine water
into pan. Leave the fill and check valves
disconnected.
To restore service, reconnect the fill valve
and the flexible tubing at the check valve.
Turn on the electrical power supply and the
water supply. Close and latch the door. Select
the Normal cycle and let the machine com-
plete the cycle. Turn off electrical power
supply. Check connections to make sure
they are watertight and do not leak.
Water outlet
/
f
Water Inlet