Preparing The Food Processor For Use; Before First Use; Work Bowl Assembly - KitchenAid KFP750 Instructions And Recipes Manual

Preparing the Food Processor for Use
Cut Hazard
Handle blades carefully.
Failure to do so can result in cuts.
4.
5.
Insert the desired accessory into
the work bowl. See page 9 for
accessory instructions.
Place the work bowl cover on the work
bowl with the feed tube just to the left
of the work bowl handle. Grasp the
feed tube and turn the cover to the
right until it locks into place.
Before First Use
Before using your Food Processor for the
first time, wash the work bowl, work
bowl cover, mini bowl, feed tube pusher,
discs, and blades either by hand or in
the dishwasher (see "Cleaning the Food
Processor" on page 13).
Work Bowl Assembly
1. Place the Food Processor base on a
dry, level countertop with the controls
facing forward. Do not plug in the
Food Processor until it is completely
assembled.
2. With the handle just to the left of
center, place the work bowl on the
base, fitting the center opening over
the power shaft.
3. Grasp the work bowl handle and turn
the bowl to the right until it locks
into position.
NOTE: To avoid damage to the work bowl,
do not attach the cover to the work bowl
before the work bowl is locked on the base.
6. Fit the 2-piece food pusher into the
feed tube.
NOTE: Your Food Processor will not
operate unless the work bowl and
work bowl cover are properly locked
on the base.
To avoid damage to the work bowl, do
not remove the work bowl from the base
without first removing the work bowl cover.