Option Selections - KitchenAid Sculptura KUDS24SE Use & Care Manual

. Canceling a cycle
You can cancel a cycle anytime during
the cycle.
1. Press the Cancel pad once, then wait.
The Cancel light will glow. There
is a 5-second pause between
the time Cancel is pressed and
draining begins.
2. Let the dishwasher drain completely.
Option selections
Press a pad to select an option. If you
change your mind, press the pad again to
turn the option off. To select a different
option, press another pad.
High Temp. Wash
Select this option, and water will heat during
the main wash for better cleaning
of heavily soiled dishes. Water
heating is automatic in the wash
portions and final rinse of the
Soak and Scrub cycle, and in the final rinse
of the Normal, Short Wash, and Light China
cycles.
Energy Saver Dry
Use this option to air dry dishes without heat.
For best results, keep the rinse
agent dispenser filled. Under
certain conditions (hard water,
empty rinse agent dispenser,
plastic items in the load, etc.) you might find
some water left on plastics, dishes, and
silverware.
SANI-RINSE* Option
The SANI-RINSE option raises the water
_ emperature in the final rinse to
155°F (68°C). SANI-RINSE is an
option with all cycles except Rinse
Only. Depending on the incoming
temperature of your water, cycle times might
be longer when you select SANI-RINSE.
NOTE= The Sani Rinse cycle raises the tem-
perature of the final rinse to approximately
155 °, and maintains that temperature for 16
minutes. This high temperature rinse sanitizes
your dishes and glassware in accordance with
the National Sanitization Foundation Interna-
tional (NSF) requirements (#95/480/05/2480).
Delay Hours
The Delay Hours light glows when the dish-
_ asher has been set for a delayed
start. The delay light will turn off
when the cycle starts. See page 21
on "Setting a delay start."