KitchenAid KEDH207WHO Use And Care Manual page 48

If You Need Assidance or Service
PROBLEM
The Self-Clean-
ing cycle will not
operate
POSSIBLE CAUSE
You have programmed a
delayed start time.
The Lock Lever is not in
the Clean position-all the
way to the right.
Fan is not running. If fan is
running, you can hear it.
WHAT TO DO
Wait for the start time to be
reached.
Move Lock Lever all the way to the
right.
Call a KitchenAid service techni-
cian for repair.
Cooking results
are not what you
expected
The range is not level.
The oven temperature
seems too low or too high.
You did not preheat the
oven before baking.
The recipe has never been
tested or is not from a
reliable source.
The pan used is not the
correct type or size.
There is not proper air
circulation around pan
when baking.
Cooking utensil does not fit
the surface unit being
used.
Level range. (See Installation
Instructions.)
Adjust the oven temperature. (See
"Adjusting oven temperature" on
page 21 .)
Preheat oven when called for in
recipe.
Use only tested recipes from a
reliable source.
Refer to a reliable cookbook or
recipe for recommended pan type
and size.
Allow 1lh to 2 inches (4-5 cm) of air
space on all sides of pan. There
must be a minimum space of 1
inch.
Pan should be the same size or
slightly larger than surface unit
being used.
The display is There has been a power Reset the clock. (See page 16.)
flashing "88:88" failure.
"F-" followed
by a number
shows in the
display
Call for service. (See Step 3 on
page 49.)
48