Door Closing; Base Grille - KitchenAid KUWS24RSSS02 Use & Care Manual

• Dispose of/recycle allpackaging materials.
When Moving Y our W ine Cellar:
Your w ine cellar i sheavy. When moving t hewine cellar f or
cleaning orservice, besure toprotect thefloor. A lways p ull
thewine cellar s traight outwhen moving i t.Donotwiggle
or"walk" t hewine cellar w hen trying tomove it,asfloor
damage could occur.
Turn theleveling l egs totheright t olower thewine cellar o r
turn theleveling legs tothelefttoraise it.Itmay take several
turns oftheleveling legs toadjust thetiltofthewine cellar.
NOTE: Having s omeone push against thetopofthewine
cellar t akes some weight offtheleveling l egs. T his makes i t
easier toadjust theleveling l egs.
Clean Before Using
After you remove all of the packaging materials, clean the inside
of your wine cellar before using it. See the cleaning instructions in
"Wine Cellar Care."
Door Closing
Your wine cellar has four leveling legs. If your wine cellar seems
unsteady or you want the door to close more easily, adjust the
wine cellar's tilt using the instructions below.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
Excessive Weight Hazard
Use two or more people to move and install wine cellar.
Failure to do so can result in back or other injury.
2. Move the wine cellar into its final location.
Open the door and check to make sure that it closes as easily
as you like. If not, tilt the wine cellar slightly more to the rear
by turning both front leveling screws to the right. It may take
several more turns, and you should turn both leveling legs the
same amount.
Remove the Base Grille
1. Open the wine cellar door.
2. Using a Phillips screwdriver, remove the two screws. Push
both tabs in toward the center to release the base grille from
the wine cellar.
................ ,,....
A B A
A. Tabs
B. Screws
3. Remove the base grille.
Replace the Base Grille
1. Open the wine cellar door.
2. Position the base grille so that both tabs align and the base
grille snaps into place. Replace the two screws. Tighten the
screws.