Advertisement
Quick Links
Download this manual
See also:
Use and Care Manual
Installation Instructions
HOME APPLIANCES
Wine Cellar
Refrigerated Wine Storage System
Important:
Read and save these instructions.
• Installer: Leave Installation Instructions
with the homeowner.
• Homeowner: Keep Installation Instructions for
future reference.
• Save these Installation Instructions for the local
electrical inspector's use.
Before installing your Wine Cellar...
Important: Observe all governing codes and ordinances.
Check that you have everything necessary for correct
installation. Proper installation is your responsibility.
Parts supplied for installation
Check that all parts were included.
• grille
Tools needed for installation
• Phillips screwdriver
• 7/32" hex driver and
rachet wrench
Location for proper performance
This appliance may be installed as a freestanding or
built-in unit. The location must provide the following:
• Grounded electrical outlet located within 4 feet of
the lower left rear corner of the wine cellar.
• Sturdy floor to support the weight of the wine
cellar (110 lb.) and contents.
• Door clearance large enough for door to open 90°
minimum. (See "Door swing dimensions.")
• Proper room temperature: Room temperature
should not fall below 55°F. Do Not install wine
cellar near an oven, radiator, or other heat source.
• Protection from weather, water and direct
sunlight.
• Open space in front of the grille. Blocking air flow
in front of the wine cellar could cause wine cellar
to malfunction. Do Not install wine cellar in a
closet or behind a cabinet door.
• literature package
• level
• gloves
®
Product dimensions
2" door
thickness
without
handle
23" overall
depth without
handle
Built-in installation: Additional clearance is not needed for air
movement. However, a 1/8" minimum clearance on sides,
top and rear of unit is recommended for ease of removal or
servicing.
Keep cardboard shipping piece or plywood under wine cellar
until it is installed in the operating position to prevent
damage to floor covering.
Door swing dimensions
top hinge
34" min.
height;
35" with
leveling legs
extended 1"
23-7/8"
width
Top front of
wine cellar
handle
90°
door
23-1/4"
Advertisement
Related Manuals for KitchenAid KUWS246EBL00
Summary of Contents for KitchenAid KUWS246EBL00
-
Page 1: Installation Instructions
Installation Instructions ® HOME APPLIANCES Wine Cellar Refrigerated Wine Storage System Important: Read and save these instructions. • Installer: Leave Installation Instructions with the homeowner. • Homeowner: Keep Installation Instructions for future reference. • Save these Installation Instructions for the local electrical inspector’s use. - Page 2 Electrical WARNING If codes permit and a separate Requirements grounding wire is used, it recommended that a qualified electrician determine that the grounding path is adequate. 3-prong grounding- type wall receptacle 3-prong grounding Electrical Shock Hazard plug Electrical ground is required. Do Not ground to a gas pipe.
- Page 3 B. Reverse door swing handle screws (optional) If not changing door swing, go to “C. Check door seal.” bottom Be careful not to scratch or chip paint. hinge Remove the handle screws from top of door. Remove bottom hinge from door. Place a large towel or soft cloth on Turn bottom hinge upside down and top of wine cellar.
- Page 4 House fuse is intact and tight; or model/serial rating plate located on the circuit breaker has not tripped. inside right wall of the wine cellar cabinet. Part No. 4344601 ©1996 KitchenAid. ®Registered Trademark of KitchenAid, U.S.A. Prepared by KitchenAid, Benton Harbor, Michigan Printed in U.S.A.