Threading Twin Needle 2:17 - Pfaff ClassicStyle 2025 Owner's Manual

Threading the twin needle:
Replace the sewing needle with a twin needle. Insert the second spool holder and place one spool of thread on each of the
spool holders. During threading in the left threading slot (17), make sure that you pass one thread each to the left and right
sides of tension disk B. Continue threading in the usual manner, making sure the threads do not become twisted together.
Pull the threads right and left into the thread guide and thread the needles (for additional details, see "Embroidering with
the twin needle").
Note: It is not possible to use the integrated needle threader with a twin needle.
Changing the needle
Switch off the main switch
To remove: Lower the presser foot and set the needle to its
highest position. Loosen the needle screw (32) and pull the
needle out downwards.
To insert: The at side A of the
needle must face to the rear.
Lower the presser foot and insert
the needle, pushing it up as far
as it will go. Hold the needle and
tighten the needle screw (32)
rmly.
B
Technical section
A
2:17