Exmark Turf Tracer HP Operator's Manual page 34

b) Engage PTO lever.
c) Look through the round hole in the left rear corner of the engine deck to
inspect blade clutching belt tension. Bolt on blade engagement linkage
bellcrank and indicator arm should align within 1/16" (.16 cm) (See Figure
13). Refer to section 5.2.2 for adjustment.
5.1.14 Lubrication
Service Interval: Refer to Chart.
a) Stop engine and wait for all moving parts to stop. Remove ignition key or
spark plug wire(s).
b) Lubricate fittings with one to two pumps of NGLI grade #2 multi-purpose
gun grease.
Refer to the following chart for fitting locations and lubrication schedule.
FITTING
LOCATIONS
1. Caster Wheel Bearings
2. Caster Pivots
3. PTO Engagement Bellcrank
4. Idler Pivot (Pump Drive)
5. Clutch Arm Pivot
6. Mower Deck Idler Pivots
7. Pump Control Bearings
No. 4 (Idler Pivot)
Located Under Engine Deck
No. 5 (Clutch Arm Pivot)
Located Under Engine Deck
No. 4 & 6 (Idler Arm Pivots)
Disassemble and grease once a month
under a "No Load" Condition.
c) Lubricate pivot points with a spray penetrating
lubricant as directed below.
PIVOT POINT
1. PTO Lever
5.1.15 Check spark plugs.
Service Interval: 160 hrs.
a) Stop engine and wait for all moving parts to stop.
b) Remove spark plugs, check condition and adjust plug gap or replace with
new plugs. See Engine Owner's Manual.
5.1.16 Remove engine shrouds and clean cooling fins.
Service Interval: See Engine Owner's Manual
GREASE LUBRICATION CHART
INITIAL
PUMPS
12
2
1
2
1
2
2
SPRAY LUBRICANT CHART
- 29 -
QUANTITY SERVICE
36" 48" 52" INTERVAL
2 2 2 8 hours
2 2 2 8 hours
1 1 1 40 hours
1 1 1 40 hours
1 1 1 40 hours
1 1 1 40 hours
2 2 2 40 hours
NO. OF SERVICE
PLACES INTERVAL
1 Weekly