Exmark Turf Tracer HP Operator's Manual page 33

Exmark mower operator's manual
Hide thumbs Also See for Turf Tracer HP:
Table of Contents

Advertisement

e)
To "prime" charge pump, loosen two hex socket head capscrews (shown in
Figure 11) 1-1/2 turns only. Make sure engine is not running. Lift
charge pump housing upward and wait for a steady flow of oil to flow out
from under housing. Retighten capscrews. Do this for both pumps.
Note: Hydraulic reservoir can be pressurized to up to 5 psi (35 kPa) to
speed this process.
f)
If either drive wheel still does not rotate, stop and repeat Steps (d) through
(e) above for the respective pump. If tires rotate slowly, the system may
prime after additional running. Check oil level as stated in Section 5.1.8.
g)
Allow unit to run several minutes after the charge pumps are "primed" with
drive system in the full speed position.
Check oil level as stated in Section 5.1.8.
h)
Check hydro drive linkage adjustment as stated in Section 5.2.6.
5.1.11
Check tire pressures.
Service Interval: Pneumatic (air-filled) Drive Tires- 40 hrs.
a)
Stop engine and wait for all moving parts to stop. Remove ignition key or
spark plug wire(s). Check air pressure in drive tires; recommended tire
pressure is 12-16 psi (83-110 kPa).
b)
Inflate tires to pressures stated above. Measure the circumference of each
drive tire. Adjust tire pressures within the above range to try to make tire
circumferences match as closely as possible.
5.1.12
Inspect Belt wear.
Service Interval: 40 hrs.
a)
Stop engine and wait for all moving parts to stop. Remove ignition key or
spark plug wire(s).
b)
Remove deck support belt shield to check mower deck drive belt condition.
c)
Look under engine deck to check the pump drive and clutching belt
condition.
d)
Check all idler arms to be sure they pivot freely. Disassemble, clean and
grease pivot bushings if necessary.
5.1.13
Inspect PTO Clutching Belt Tension.
Service Interval: Check every 2 hrs. for first 8 hrs. operation then check
a)
Stop engine and wait for all moving parts to stop.
FIGURE 8
CHARGE PUMP LOCATION
Semi-pneumatic Caster Tires – No maintenance
every 40 hrs. thereafter.
- 28 -

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents

Save PDF