Exmark Turf Tracer HP Operator's Manual page 21

This will give an approximate setting for drive lever linkages; you will need to refer
to Section 5.2.6 step d to complete the drive lever linkage adjustment.
DRIVE LEVER LINKAGE INSTALLATION
3.14 Connect wiring harness.
For recoil start models: Route the long unattached portion of the wiring harness
up the left handle and under the console. Connect the connector on the end of the
shorter lead to the key switch. Connect the two flag terminals that are in the longer
lead to the OPC switch in any order. Continue routing this lead down the right side
of the handle and connect the connector on the end of it to the park brake switch.
Fasten the harness to the left hand side of the handle using two large ties from the
bolt bag. Fasten the harness to the right hand side of the handle using two small
ties from the bolt bag. On ECS models fasten the harness to the two small holes in
the channel under the console using two small ties from the bolt bag.
For electric start models: Route the long unattached portion of the wiring
harness up the left handle and under the console. Connect the two flag terminals
to the OPC switch in any order. Connect the connector to the key switch. Fasten
the harness to the left hand side of the handle using two large ties from the bolt
bag. On ECS models fasten the leads connecting to the OPC switch to the small
hole in the channel under the console using a small tie from the bolt bag.
3.15 If machine is shipped without muffler installed, install muffler with hardware
provided.
3.16 SERVICE ENGINE: Refer to Engine Owner's Manual.
3.17 SERVICE HYDRAULIC OIL
The machine is shipped with hydraulic oil filled to the top of the baffle in the
reservoir. Run the machine for approximately 15 minutes to allow any extra air to
purge out of the hydraulic system. Check hydraulic reservoir and if necessary fill
the reservoir to the appropriate level with Mobil 1 15W-50 synthetic motor oil.
Replace hydraulic reservoir cap and tighten until snug. Do not overtighten.
The baffle is labeled "HOT" and "COLD". The oil level varies with the temperature
of the oil. The "HOT" level shows the level of oil when it is at 225° F (107°C). The
"COLD" level shows the level of the oil when it is a 75°F (24°C). Fill to the
appropriate level depending upon the temperature of the oil. For example: If the
oil is about 150°F (65°), fill to halfway between the "HOT" and "COLD" levels. If
the oil is at room temperature (about 75°F (24°C)), fill only to the "COLD" level.
3.18 GREASE UNIT: NOTE: UNIT IS NOT GREASED AT THE FACTORY.
Refer to 5.1.14, for locations and grease amounts.
FIGURE 4
ECS HANDLES
- 16 -