Transporting - Exmark Turf Tracer HP 4500-358 Operator's Manual

Figure 8
For cutting heights above 3.5 inches (38 mm) use the
bottom hole. The rollers will still be effective against
scalping.
1. Anti-scalp roller
mounting bracket
7. Torque the 3/8–16 whizlock nut to 30-35 ft-lb
(41-47 N-m) (Figure 9).
8. If the 3/8 nyloc nut has been removed, reinstall
and torque to 30–35 ft-lb (41-47 N-m) (Figure 9).
Figure 9
1. Spring disc washer
(cone towards nut )
2. Front right anti-scalp
bracket shown
2. Cutting height
3. 3/8 nyloc-torque to 30-35
ft-lb (41-47 N-m)
4. 3/8-16 whizlock nut
torque to 30-35 ft-lb
(41-47 N-m)

Transporting

Transporting a Unit
WARNING
Loading the mower onto a trailer without
strong enough or properly supported ramps
could be dangerous. The ramps could
collapse causing the unit to fall, which could
cause injury.
• Use proper ramps that are secured to the
truck or trailer.
• Keep feet and legs out from under the
unit when loading and unloading.
• If necessary, use assistance when loading.
Be sure the fuel shut-off valve is closed.
Use a heavy duty trailer to transport the machine.
Engage neutral lock latches and park brake, then
block wheels.
Securely fasten the machine to the trailer with straps,
chains, cables, or ropes.
Do Not rely solely on the parking brake to hold the
machine on the trailer.
Be sure that the trailer has all necessary lighting and
marking as required by law and use a safety chain.
23
Operation