Troubleshooting - GE JGBP36 Owner's Manual & Installation Instructions

Before gou call for service...
Troubleshooting Tips
Possible Causes What To Do
Excessivesmoking Excessive soil. • Touch the Clear/Off pad.
Oven door will not open Oven too hot. * Allow the oven to cool below locking temperature.
after a clean cgcle
Oven not clean after Oven controls not properly set. • See the Using the self-cleaning oven section.
a clean cgcle Oven was heavilg soiled. • Clean up heavg spillovers before starting the clean cgcle.
Heavily soiled ovens may need to self-clean again or for
a longer period of time.
Oven doorwill not Oven is too hot. • Allow the oven to cool below locking temperature.
unlock (on models Do not lock the door with the door latch except when
with a door latch) using the self-clean feature.
Self clean light blinks A power interruption occurred. * Touch the Clear/Offpad, wait for the oven to cool, and
during self clean cgcJe on models with a latch, move it to the left as far as
it will go. Reset the range controls to the desired
settings. See the Using the self-cleaning oven section.
Self-cleaning cgcle has been
selected, but the oven door was
not closed, and on models with a
latch, it was not moved all the
wag to the right.
Closethe oven door.On models with a latch, move it all
the way to the right.
On models with a latch, it
was moved to the right, but a
program other than self-cleaning
was selected.
• Hove the latch handle to the right only when setting
the self-cleaning cycle.
"F--and a number or On models with a door latch, * The latch may have been moved, even if only slightly,
letter" flash in the if a function error code appears from the locked position. Hake sure the latch is moved
display
(oosomemodels) during the self-cleaning cycle, to the right as far as it will go.
check the oven door latch.
You have a function error code. • Touch the Clear/Off pad. Allow the oven to cool for
one hour. Putthe oven back into operation.
If the function code repeats. • Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
48