Oven Light Replacement - GE JGBP36 Owner's Manual & Installation Instructions

GEAppliances.com
Oven Racks
Clean the racks with an abrasive cleanser or
scouring pad. After cleaning, rinse the racks
with clean water and drg with a
clean cloth.
If the racks ever become hard to slide, wipe
the rack edges or oven rack supports with
vegetable oil.
NOTE: Take the racks out of the oven before
gou begin the self-clean cgcle or theg mag
discolor.
Wire cover holder.
Oven Light Replacement
^,., C AUTION:Before replacing your
oven light bulb, disconnect the electrical power
to the range at the main fuse or circuit breaker
panel Be sure to let the light cover and bulb
coo! complete!g.
The oven light bulb is covered with a
removable glass cover that is held in place
with a bail-shaped wire. Removethe oven
door, if desired, to reach cover easilg.
To remove:
Hold a hand under the cover so it
doesn't fall when released.With fingers
of the same hand, firmly push back the
wire cover holder.Lift off the cover.
Do not remove any screws to remove
the cover.
[21 Do not touch hot bulb with a wet cloth.
Replacebulb with a/40-watt household
appliance bulb.
To replace coven
[] Placeit into the groove of the light
receptacle. Pull the wire forward to the
center of the cover until it snaps into
place.When in place, the wire holds the
cover firmly. Be certain the wire is in the
depression in the center of the cover.
[] Connect electrical power to the range.
33