GE JGBP36 Owner's Manual & Installation Instructions page 34

m
Install tion Instructions Ra e
ir?i Questions? Call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com I
In Canada, call 1.800.561.3344 or visit www.GEAppliances.ca
In the Commonwealth of Massachusetts:
• Thisproduct must be installed bg a licensedplumber
or gas fitter.
• When using ball-tgpegas shut-off valves,theg shall
be the T-handletgpe.
• A flexible gus connector,when used,must not exceed3 feet.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Installation of this range must conform with local
codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA.54, latest
edition. In Canada, installation must conform with
the current Natural Gas Installation Code, CAN/CGA-
B149.1 or the current Propane Installation Code,
CAN/CGA-B149.2, and with local codes where
applicable. This range has been design-certified by
CSA International according to ANSI Z21.1, latest
edition and Canadian Gas Association according to
CAN/CGA-I.1 latest edition.
As with ang appliance using gas and generating heat,
there are certain safetg precautions gou should follow.
You will find these precautions in the Important Safety
Information section in the front of this manual. Read
them carefullg.
• IMPORTANT - Save
these instructions for
local electrical inspector's use.
"IMPORTANT - Observe all g overning codes
andordinances.
• Note to Installer
- Be sure to leave these
instructions with the Consumer.
• Note to Consumer - Keep
these instructions for
future reference.
•
Note
- This appliance must be properlg grounded.
•
Servicer
-The electrical diagram is in an envelope
attached to the back of the range.
• Skill level- Installation of this appliance requires basic
mechanical skills.
• Proper installation is the responsibilitg of the installer.
• Product failure due to improper installation is not covered
under the Warrantg.
PART INCLUDED
Anti-Tip brarket k it
34
FOR YOUR SAFETY
Do not store or use combustible materials, gasoline or
other flammable vapors and liquids in the vicinitg of this
or any other appliance.
If you smell gas:
O Open windows.
O Don't touch electrical switches.
Extinguishang open flame.
Immediatelg call gour gas supplier.
TOOLS YOU WILL NEED
Phillipsscrewdriver
Flat-bladescrewdriver 0pen-endor
adjustablewrench
Penciland ruler
Level
Pipewrenches(2)
(onefor backup) Drill, awl or nail
MATERIALS YOU MAY NEED
•Gas line s hut-offvalve
Pipe j oint sealant o rUL-approved p ipe thread topewith
Teflon* that resists action o fnatural and LPgases
Flexible metal appliance connector ( 1/2" I .D.)
A S-foot length is recommended for easeofinstallation
but other lengths are acceptable. Never use an old
connector when installing a new range.
Flareunion adapter for connection to gas supplg line
(3/4" or 1/2" NPTx 1/2" I.D.)
• Flareunion adapter for connection to pressure regulator
on range (1/2" NPTx 1/2" I.D.)
• Liquid leak detector or soapg water.
• Lag bolt or 1/2" O.D.sleeve anchor (for concrete floors
onlg).
•Teflon: Registered trademark of DuPont