Assembling Deep Cleaner; Attach Upper Handle - Hoover SteamVac F5851 Owner's Manual

Assembm[ng deep
cleaner
The assembled cleaner will look like this drawing,
Attach upper haadme
Remove clean solution tank
(upper tank) (Fig. 1),
Remove nozzle stored on upper
handle by gently pushing nozzle
downward while pivoting it away
from the handle at (B)
!
CORD
HOOK
With cord hook to back of deep cleaner, push
upper handle down onto lower handle. (Fig.3).
i
_ush bolts into holes on front of handle (Fig. 4),
If bolts will not go through hole easily handle is not pushed
completely down.
Place nuts in recessed areas on back of handle, Hold each
nut in place while tightening each bolt securely with a Phillips
screw driver (Fig, 5).
Only two nuts are needed on this model. The extra nut is not
required but has been provided for your convenience.
!_SQUEEZE
; ll_ TRIG GER
When handle sections are completely together, squeeze
trigger on upper handle to snap trigger rod in place (Fig. 6).
/
\
Replace clean solution tank (upper tank) by positioning bottom
first. Press on tank handle to snap lop of tank into place (Fig, 7).
Continued -_
Assembly 3