Replacing Headlight - Hoover U5759-900 Owner's Manual

Headlight replacement
Disconnect cleaner
from electrical
outlet.
_MI il
What to buy
lhis cleaner uses
a 12 voll, wedge
base type 912 bulb,
Hoover part No.
27313101.
Removing lens
Disconnect cleaner
From electrical
outlet.
Using a screwdriver,
remove the two
screws as shown
and lift olTlens.
Installing bulb
Pull old bulb straight
out of socket, Push
ne_ bull:} straight
into socket until
locked in place.
Excessive force is
not required.
Replacing lens
Repositiun lens and
secure
with the two
ScIeWS,
Belt replacement
Belt replacement
'lh_ belt on your HOOVER cleaner causes
the agitator to rotate and is important
for
the effective operation of the cleaner. The
helt is located under the bottom plate of the
cleaner and should be checked from time to
time to be sure it is in good condition.
When to replace
Disconnect cleaner from electrical outlet.
To check beIt, remove bottom plate as
shown in "How to replace." Replace belt if
it is streLehed, cut or broken.
What to buy
To assure effective operation, use only gen-
uine HOOVER belts with your cleaner. When
purchasing a new belt, ask for Hoover part
No. 38528033.
How to replace
Disconnect cleaner
from electrical
outlet.
Place handle in low
position and turn
cleaner over so
bottom side is up.
Remove the 4
screws aS shown
with a Phillips
'screw driver.
Lift off bottom
plate (A).
Removing belt
Remove agitator
brush to]} and used
belt.
Discard used belt.
12
Installing new belt
With lettering
on
outside of belt and
positioned as shown
in box on (D}, slide
new belt over motor
pulley (B).