(Some Models) - Frigidaire DGGF3054KFN Use & Care Manual

Problem Solution
Flames inside oven or smoking from • Excessive spillovers in oven. For example this will happen for pie
oven vent. spillovers or large amounts of grease left on the oven bottom. Wipe up
excessive spillovers before starting oven. If flames or excessive smoke
are present see "Broiling" in the Setting Oven Controls section for
additional recommendations.
Oven smokes excessively when broiling. • Incorrect setting or food preparation. Follow broiling instructions in
Setting Oven Controls section.
• Make sure oven door closed when broiling.
• Food positioned too close to upper broil burner. Reposition the food
item lower if necessary to provide proper clearance between the food &
the broil burner. Try preheating the oven before boiling.
• Food not properly prepared. Remove excess fat from meat. Cut
remaining fatty edges to prevent curling.
• Broil pan and insert (some models) wrong side up and grease not
draining. Always place insert on top of broil pan with ribs up & slots
down to allow excess grease to drip into broil pan.
• DO NOT USE ALUMINUM FOIL. Aluminum foil will trap grease, expose
grease to high temperatures and increase smoking.
• Grease has built up on interior oven surfaces. Regular cleaning is
necessary if broiling frequently. Old grease or food spatters cause
excessive smoking.
Convection does not work • Oven control not set properly. Review instructions for "Convect" in
(some models) "Setting Oven Controls" section.
• Allow 6 minutes for the convection fan to start rotating after setting a
convection feature.
• See "Convection fan does not rotate" in this checklist.
Convection fan does not rotate • Allow 6 minutes for the convection fan to start rotating after setting a
(some models), convect feature.
• Oven door is open. The convection fan will turn off if oven door is opened
when any convect feature is active. Close oven door.
Self-cleaning cycle does not work. • Oven control not set properly. Follow the instructions provided in the
"Self-cleaning" section of this manual.
• Self-clean cycle was interrupted. Refer to the "Self-Cleaning" section for
more detailed information.
Soil not completely removed after • Dirty front oven frame outside oven door gasket area. These areas are
running a self-cleaning cycle, not within the self-clean area, but get hot enough to burn on residue.
Manually clean these areas before starting a self-clean cycle. Burned-on
residue can be cleaned using a stiff nylon brush, or a nonabrasive nylon
scrubber and water. Be careful not to damage the oven door gasket.