Operating Controls And Adjustments - Delta 28-150 Instruction Manual

OPERATING CONTROLS AND ADJUSTMENTS
STARTING AND
STOPPING SAW
The switch (A) Fig. 20, is located on the front side of the
band saw. To turn the saw "ON" move the switch (A) to
the up position. To turn the saw "OFF" move the switch
(A) to the down position.
LOCKING SWITCH IN
THE "OFF" POSITION
When the tool is not in use, the switch be locked in the
"OFF" position. This can be done by grasping the switch
toggle (B)Fig. 21, and pulling it out of the switch, as
shown. With the switch toggle (B) removed, the switch will
not operate. However, should the switch toggle be
removed while the machine is running, the switch can be
turned "OFF" once, but cannot be restarted without
inserting the switch toggle (B).
Fig. 2O
OPENING AND CLOSING
HINGED DOOR
For the purpose of making adjustments such as changing
the blade, tracking the blade, blade guide adjustments,
etc., the hinged door (B) Figs. 22 and 23, must be opened
as follows:
1. CAUTION: NEVER OPEN THE HINGED DOOR
WHEN THE MACHINE IS RUNNING.
2. Press in the two locking latches (A) Fig. 22, and swing
door (B) open.
3. Fig. 23, illustrates door (B) in open position.
4. To close and fasten door (B) Figs. 22 and 23, press on
door directly over latches (A) Fig. 22, until latches snap
into the locking position.
Fig. 21
B
Fig. 22
10 Fig. 23