5. Locate pinionknob(N)Fig.9,spring (O), a ndspecial
screw(P).
6. Positionpinionknob(N)Fig.10, ontothe backof
sawsothattheteethonthe pinionknob(N)engage the
teeth on the trunnion(R).Fasten in placewith special
screw(P)andspring using thesupplied 4mmwrench.
Fig.9
7. Fasten pointer (S)Fig.11,to the backof bandsaw
usingthe M5x 10mmscrew(T).
8. Usingthe supplied4mm Hex socketwrench,re-
assemble tablelockinghandle(F)Fig.11,on studand
.....
replace screw andspring (D).NOTE: H andle (F)is spring-
loadedandcanbe repositioned o n the stud by pulling
outthe handle andrepositioning i ton thenut.
Fig.10
9. InsertM6x 30mmscrew(W)Fig.12,downthrough
holeintable, a s shown, a ndfasteninplacebyusingM6
flatwasher a ndM6wingnut (X).
Fig.11
Fig.12
6