Kenmore 116.23312 Owner's Manual page 16

TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high end to prevent damage to your vacuum,
the agitator must be cleaned every time th_
belt is changed.
The agitator must also be cleaned according
to the following schedule:
Vacuum Use
HEAVY -
(used daily)
MODERATE -
(used 2-3 times/week)
LIGHT -
(used 1 time/week)
Clean Agitator
every week
every month
every 2 months
IMPORTANT
Disconnect cleaner from electrical outlet.
Check and remove hair, string and lint build-
up frequently in the Power-Mate ® agitator and
end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris locat-
ed on the agitator, or end caps.
Agitator Assembly
Brush Unit
End Cap
L- Belt Pulley
TO REPLACE BELT
MoOr
Drive
Brush
Brush Brush Sprocket
Suppo_
2. Snap brush --
supports into
)lace on base.
Be sure brush
supports are not
upside-down.
Cover Base
4. Rotate cover
back. Press cover
firmly until side
tabs snap into
place. Replace
cover screws,
light bulb and
light cover,
1. Install new
belt over
motor drive,
then over
brush sprock-
et.
NOTE: See
PARTS AND
FEATURES
for Belt #.
3. Line up
front of cover
and base.
Rest cover on
front edge of
base as
shown.
16