Light Bulb Changing - Kenmore 116.23312 Owner's Manual

1. Remove light
cover by pressing
in and lifting both
sides as shown•
TO REMOVE BELT
1. Remove light cover and light bulb as
shown under LIGHT BULB CHANGING.
2. Unscrew the Power-
Mate ® cover screws.
3. Turn Power-
Mate ®over. To
remove cover,
insert
screwdriver at
cover tabs on
both sides and
twist to release
tabs.
Tab
Push In _ 2, Push in and turn
And Turn r_,q.._
bulb counterclock-
wise to remove.
3. Replace the bulb•
Bulb must not be
higher than 15 Watts
__ (130V). Close light
cover until it snaps in
place.
NOTE: See PARTS AND FEATURES for
Bulb #.
4. Turn Power-
Mate ®right side
up. Press handle
release pedal and
lower the swivel.
Rotate cover
forward from back
• \ until front snaps
free.
5. Carefully
insert and lift
screwdriver
at each
brush
support to
free brush
from base.
6. Remove
worn belt.
Brush
Suppo_
i
Base
7. Check and clean brush support areas. See
AGITATOR ASSEMBLY for picture of
complete brush assembly.
15