Display - Kenmore 580.74156 Owner's Manual

DISPLAY
I FAN SPEED
•Every time you push this button, it advances the setting as follows: {High -_ Low -_ Med-_ High}
REMOTE CONTROL SlGNAL
RECEIVER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, Timer sets number of hours untit shut-off.
• Every time you push Timer button, it advancesthe Timer setting
as follows: 1 Hour-* 2 Hours........ 12 Hoursmaximum.
- START TIME
•If unit is off, Timer sets number of hours before unit starts.
SETTING
• This button can automatically control the
temperature of the room.
The temperature can be set within a range
of 60°F to 86°F by increments of 1°F.
POWER
• To turn the air conditioner ON, push the
button.
To turn the air conditioner OFF, push
the button again.
• This button takes priority over any other
button.
• When you first turn it on, the air conditioner is
on the High cool mode and the Temp. at 72°F.
•Every time you push Timer button, it advancesthe Timer setting as follows: 1 Hour -, 2 Hours......... 12 Hours
maximum.
MODE
- Every time you push this button, it will shift among COOL, ENERGY SAVER and FAN.
- ENERGY SAVER:
• The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and check the room air to determine if cooling is
needed.
In failure of electric power, the unit runs as previous setting operation.
HORIZONTAL AIR DIRECTION CONTROL VERTICAL AIR DIRECTION CONTROL
The vertical air direction is adjusted by moving the
The horizontal air direction is adjusted by moving horizontal louvers up and down with your fingertips.
the vertical louvers right and left with your (FIG. 25)
fingertips. (FIG. 24)
FIG. 24 FIG. 25
-11-