Kenmore 116.22512 Owner's Manual page 15

1. Remove light
cover by pressing
in and lifting both
sides as shown.
Push In _
2. Push in and turn
And Turn ["_._ bulb counterclock-
-._.. wise to remove.
_---___t 3. Replace the bulb,,
__ Bulb must not be
higher than t5 Watts
(130V)o Close light
cover until it snaps in
places _o_
NOTE: See PARTS AND FEATURES for
Bulb #.
E CAUTION
When you remove the end caps, a
small metal washer on each end
may come off. DO NOT lose these
two metal washers.
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacuum,
the agitator must be cleaned every time the
belt is changed.
The agitator must also be cleaned according
to the following schedule:
Vacuum Use
HEAVY -
(used daily)
MODERATE -
(used 2_3 times/week)
LIGHT -
(used I time/week)
Clean A_itator
every week
every month
every 2 months
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove
any string or
debris located on
the agitator, end
caps, washers or
agitator shaft,
IMPORTANT
Replace the washers and the end caps,
See the exploded view for correct
assembly.
Disconnect cleaner from electrical outlet.
Check and remove hair, string and lint build-
®
up frequently in the Power-Mate agitator
and end cap areas. If build-up becomes
®
excessive, disconnect Power-Mate from
wand and follow the steps below_
15