Starting/Canceling A Function; Ultrabake Tmbaking/Roasting - Kenmore SELECT CLEAN 665.75827 Use & Care Manual

STARTING/CANCELING A FUNCTION
After setting a function, you must press START/
ENTER to start the function. If you do not
START_ press START/ENTER within 5 seconds of
mR setting, "START?" will show on the
display as a reminder. If you do not press
START/ENTER within 5 minutes of setting, the time
of day will appear. You must reset the function and
press START/ENTER.
OFF/CANCEL will cancel any function except the
Clock, Timer, or Oven Lockout. When you
OFF press OFF/CANCEL, the display will show
CANCH the time of day or, if the minute timer is also
being used, the time remaining.
ULTRABAKE TMBAKING/ROASTING
Your oven is designed with the ULTRABAKE
TM
enhanced baking system to constantly monitor
oven temperature. The bake burner will cycle, as
needed, to maintain the desired temperature. This
feature is automatically activated when the oven is
in operation.
IMPORTANT:
• When using the oven for the first time, it is
necessary to light the surface burners first to
purge air from the gas lines.
• Do not try to light the oven burner during a
power failure.
• Never place food or cookware directly on the
oven door or the oven bottom.
1. Place the STURDIGLIDE
TM
rack(s) where you
need them in the oven. For more information, see
the "Positioning racks and pans" section, p. 9.
2. Press BAKE. PRESS YOU SEE
BAKE
3. Set the temperature (optional). PRESS
Do this step if you want to set a temperature TEMP
other than 350°F. Press TEMP (,k) or (_') pad(s) j_,
to raise or lower the temperature in 5°F amounts.
Use these pads until the desired temperature
shows on the small display.
YOU SEE
(example for bake at 375°F)
F
15