Starting/Canceling A Function; Ultrabake Tm - Kenmore Sens-A-Clean 665.95822 Use & Care Manual

STARTING/CANCELING A FUNCTION
After setting a function, you must press START/
ENTER to start the function. If you do not
START__press START/ENTER within 5 seconds of
ENTE. setting, "START?" will show on the
display as a reminder. If you do not press
START/ENTER within 5 minutes of setting, the time
of day will appear. You must reset the function and
press START/ENTER.
OFF/CANCEL will cancel any function except the
Clock, Timer, or Oven or Cooktop Lockouts.
OFF When you press OFF/CANCEL, the display
CANCELwill show the time of day or, if the minute
timer is also being used, the time remaining.
ULTRABAKE
TM
BAKING/ROASTING
Your oven is designed with the ULTRABAKE
enhanced baking system to constantly monitor
oven temperature. The bake and broil elements
will cycle, as needed, to maintain the desired
temperature. This feature is automatically activated
when the oven is in operation.
IMPORTANT: Never place food or cookware
directly on the oven door or the oven bottom.
1. Place the STURDIGLIDE
TM
rack(s) where you
need them in the oven. For more information, see
the "Positioning racks and pans" section, p. 12.
2. Press BAKE. PRESS YOU SEE
BAKE
3.
Set the temperature (optional). PRESS
Do this step if you want to set a temperature TEMP
other than 350°F. Press TEMP (A) or (V) pad(s) j_.
to raise or lower the temperature in 5°F amounts.
Use these pads until the desired temperature
shows on the small display.
YOU SEE
(example for bake at 375°F)
18