Listening To The Radio; Tuning In To A Station; Preset Tuning; To Adjust The Reception Condition - JVC RV-NB10W Instructions Manual

Listening to the radio
Number buttons-
l<1<1-
_SET
W,RE,ESS/FMJAM
_lvc
WIRELESS/
PRESET TUNING FM/AM
You can listen to FM and AM stations. Stations can be tuned in manually, automatically, o1"from preset memory storage.
@ Before listening to the radio, tully extend the FM telescopic antenna.
Press W|RELESS/FM/AM ,epeatedly to
select either FM or AM.
Each time you press WIRELESS/FM/AM, tile hand changes as
follows:
WIRELESS -+ FN -+ AN -+ (back to the beginning)
, For _WIRELESS," see page 17.
The system tunes in to the last tuned station. The following
information appears on the display.
When "Manual Tuning" or _Auto Tuning" was used to tune in
to the last tuned station (see below), the band frequency
appears.
||||| iii iii iiiii IIIIIi IIIIII
I I II
r"!'! ',:::', (,:',',)
When "Preset Tuning" was used to tune in to the last tuned
station (see the right column), the preset number (displayed
as '_P-XX" on the display) and then the band frequency
appear.
i"' i','i i"' 'i "', i'' i','i "" "" '....
..... "* r" !! ;:;(.:i)
r" !'! r" .L.,::.
(After one second) _"
_ Select _ st_.e..si., e.e ofthe felle_i.g
methods.
• if an FM stereo broadcast is hard to receive or
noisy, press FM MODE on the remote control. The MONO
indicator lights up and the sound becomes monaural but the
reception improves. When you tune in to another station, the
MONO indicator goes off and stereo effect restores
automatically.
Note: AM broadcasts are monaural.
® Manual Tuning
Press I<1-,_or _1_1 repeatedly to move from frequency to
frequency until you find the station you want.
OR
® Auto Tuning
Press and hold I-,4-_tor _-_1 for one second or more.
The frequency changes automatically until a station frequency
is foulld.
OR
N Preset Tuning (possihle only after presetting stations)
Select the desired preset number using PRESET TUNING on
the system or the number buttons on the remote control. The
preset number and then the band frequency appear on the
display.
PRESET TUNING button: Each time you press the button, the
preset number increases.
Number buttons: To select P-5, press 5.
To select P-15, press +10 then 5.
To select P-20, press +10 once then
press I0.
Notice: To adjust the reception condition
For FM: Adjust tile FM telescopic antenna's length, angle and
direction until the best reception is obtained.
For AM: Change the direction of the system to obtain the best
reception.
Placing the system near the window, for example, will
improve AM reception.
9