JVC HR-J220U Instructions Manual page 27

Timer-Recording Problems?
Symptoms
Timer recording is not possible.
Timer programming screen does not function
properly.
"TIMER" and "[_" on the display panel
continue blinking.
The cassette is automatically ejected.
"TIMER" and "[_]" continue blinking.
Check points
• Have you set the clock correctly and programmed the timer correctly?
-- Check once again.
• Have you set the VCR's tuner?
-- Check once again.
• Is the TIMER indicator displayed on the display panel?
-- If not, press the TIMER button to display the TIMER indicator.
• Is the ITR indicator displayed on the display panel?
-- Timer programming is not possible while an ITR is in progress.
• There is no cassette in the VCR.
-- Insert a cassette with the safety tab intact.
• The inserted cassette has its safety tab removed.
-- Insert a cassette with its safety tab intact. Or cover the safety tab hole of the cassette with
adhesive tape and re-insert it. _ p.19.
There are no preset programs in memory, or they have all been incorrectly preset.
-- Check the programmed data and re-program it a_snecessary. Press TIMER again.
This means that the end of the tape was reached while timer-recording was in progress.
Therefore, the preset program may not be recorded in its entirety.
"TIMER" blinks for 10 seconds and the timer •
mode is cancelled.
The cassette is ejected, power is shut off and •
"TIMER" and "[_" are blinking.
Other Problems?
Symptoms Check points
Some channels are skipped over when
• Those channels ate preset to be skipped over. If you need them, restore them. (a:7"p.14)
scanning channels.
Channel cannot be changed. • Is recording in progress?
-- Press the PAUSE button, change the channel, and press the PLAY button.
Snowy picture on screen when viewing TV • Is the VIDEO indicator lit?
programs while recording another program. -- Press the TV/VIDEO button.
Remote control does not operate my TV. • Although the provided remote control unit is compatible with JVC televisions as well as
many TV models manufactured by others, it is possible that the provided remote control will
not operate your TV, or in some instances, will have limited function capability. (c_" p.23)
• Is the remote control's TV/CABLE/VCR switch set to "TV"?
--If not, set it to "'IV". _:
"12:00 AM" is blinking. • This means the clock must be set. It's displayed when time-keeping is terminated due to a
power failure or because the VCR's power plug was pulled from the AC outlet.
To set the clock. _2" p.12. If power was interrupted, it's also likely that all preset timer
programming data has been erased. Please check and re-program as necessary.
ATTENTION:
This recorder contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch the power off
and unplug the power cord. Then plug it in again and switch power on. Take out the cassette. After checking the cassette, operate the unit as usual.
27