Frigidaire FPGF3685LSA Use & Care Manual page 23

Cleaning Burner Heads, Caps & Grates
The cooktop is designed to make cleaning easier. Because
the gas Burners are sealed, cleanups are easy when
spillovers are cleaned up immediately.
The cooktop, Burner Heads and Caps should be routinely
cleaned. Keeping the Burner Head Ports clean will
prevent improper ignition and an uneven flame. Refer to
the following instructions:
THE COOl(TOP IS NOT REMOVABLE. Do not
attempt to remove or lift the cooktop.
THE FIXED OVEN VENT IS NOT REMOVABLE, Do
not attempt to remove the fixed oven vent cover.
Burner
Cap
Surface
Burner
Head
Use caution when replacing the Burner Caps so the
Electrodes are not damaged. This may cause a delayed
t!o orPr e
burne
0 ! !ting: .....................................................................
To Remove and Replace the Surface Burner Caps
and Burner Heads - Remove in the following order:
(1st) surface Burner Grates, (2nd) Burner Caps and (3rd)
Burner Heads. Replace in the following order: Burner
Heads, Burner Caps and Burner Grates.
Do not remove any parts from the cooktop
until they have completely cooled and are safe
to handle. Do not operate the surface Burners
without the Burner Caps and Burner Heads
properly in place.
To Clean the surface Burner Caps and Burner
Heads- Use a soap-filled scouring pad or a mild abrasive
cleanser to clean the surface Burner Caps and Burner
Heads. The ports (or slots) around the Burner Heads
must be routinely cleaned. If residue still remains in these
ports, use a small-gauge wire or needle to clean the
slots or holes. For proper flow of gas and ignition of the
burner--DO NOT ALLOW SPILLS, FOOD, CLEANING
AGENTS OR ANY OTHER MATERIAL TO ENTER THE
GAS ORIFICE HOLDER OPENING. ALWAYS keep the
surface Burner Caps and Burner Heads in place whenever
the gas Burners are in use.
To Clean the BarBer Grates- The Burner Grates are
dishwasher safe and may be cleaned in the dishwasher.
Remove any excessive soils before placing in the
dishwasher.
Electrode
Orifice
holder
Care and cleaning of stainless steel
Some models are equipped with stainless steel exterior
parts. Special care and cleaning are required for
maintaining the appearance of stainless parts. Refer
to the General Care & Cleaning table for detailed
cleaning instructions.
Removing and Replacing Oven Bottom
To Remove the Oven Bottom:
Grasp the oven bottom by the front corner on each side,
slide toward you and lift up the oven bottom.
To Replace the Oven Bottom:
1. Grasp the oven bottom and position the back tabs in
place in the slots at the rear of the oven.
2. Lower the front of
the oven bottom
and slide into place.
Grasp the oven bottom by
the front corner on each
side to raise and lower the
oven bottom.