Jenn-Air WW27110 Use And Care Manual page 30

Door and control panel trim
The metal trim around the door and the control panel can be cleaned with a household
cleaner or soapy water, rinse well. Be careful not to use an excessive amount of water,
Glass on the oven door front
Use any suitable glass cteaner or soapy water.
Control Panel Area and Display Window
Wipe with paper towels dampened with soapy water or glass cleaner. Do not spray any
cleaning solutions directly onto the Display window or use large amounts of soap and
water, Do not scrub with S,O.S. pads or abrasive cleaners.
To remove pull forward to the "stop" position; lift up
on the front of the rack and pull out.
Before replacing bulb, disconnect power to oven at the main fuse or circuit breaker
panel. Be sure that the entire oven cavity including the bightbulb is cool before attempting
to remove.
To replace light bulb
1. Carefully unscrew the glass light lens,
2. To obtain firm grasp on the bulb, wear protective rubber
gloves. Remove by turning bulb to the left, Do not touch a
hot oven light bulb with a damp cloth as bulb will break. Note:
If the bulb does break and you wish to remove it, be certain
power supply is disconnected and wear protective gloves.
You may contact your authorized Jenn-Air Service Contractor
for service.
3. Repface bulb with a 40 watt oven-ratedappliance bulb. Bulb
with brass base is recommended to prevent fusing of bulb
into socket.
4, Replace bulb cover and reconnect power to oven. Reset
clock.
J
31