Jenn-Air JCB2285KEF Use & Care Manual page 5

Door and Hinge Removal
Some installations require door removal to get
refrigerator to final location.
1. Unplug power cord from power source.
2. Remove toe grille and bottom hinge covers (see
page 9).
• Open both doors 180 °, or as wide as possible.
For ice and water dispensing models only:
Remove the left side hinge cover by carefully
pulling the water line to pry the cover loose. Then
continue to maintain downward pressure to the
notched side of the cover while swinging it off
(see page 9).
Note
• For refrigerators in operation, shut off water before
removing water line from the door.
To Disconnect the Water Line:
Push in white collar (A_)and hold.
Pull the door-side tube from the connector (B_).
To Reconnect the Water Line:
Firmly push tube _" into the connector. Use
lines on the tube as a guide for full insertion.
If tube end is damaged, cut off %" before
reco n n ecti n g.
If leaking occurs,
reconnect the line.
3. Close doors.
4_
5_
6.
Remove top hinge covers by
removing Phillips screws.
Unscrew Y,_"hex head screws from
top hinges.
For ice and water dispensing .............
modems onmy: Detach main wire
connector harness.
Do not remove screw
connecting green ground wire.
To detach main wire harness,
use a flat blade tool or finger-
nail to press junction point
between two connectors to
release.
7. Remove top hinges along with doors.
8. Remove bottom hinges with a _8"hex head driver.
Replacing the Doors
• To replace the doors, follow the steps in Door and
Hinge Removal in reverse order.
IMPORTANT: If water line tube end is damaged, cut
off %" before reconnecting.