Advertisement
Available languages
Available languages
OOKING
To set the Clock:
1. Press the Clock pad.
Clock
, The time of day flashes in the display.
2. Press the appropriate number pads to set the time of day.
, Colon flashes in the display.
3. Press the Clock pad again or wait four seconds.
, The colon will remain on.
When electrical power is supplied or after a power interrup-
tion, the last clock time before power was interrupted will
flash.
To recall the time of day when another time function is
showing, press the Clock pad.
Clock time cannot be changed when the oven has been
programmed for Delay cook or clean or Cook & Hold.
To cancel
the Clock display:
If you do not want the time of day to display:
Press and hold the CANCEL and Clock pads for
CANCEL
three seconds. The time of day will disappear
.....
from the display.
............... ,
When the clock display is canceled, press the
, Clock
}
Clock pad to briefly display the time of day.
............
When the clock display is canceled, after 15 minutes, the oven
control will go into Standby Mode to save energy. The display
will be blank and the oven light will not operate. To "wake up"
the control from Standby Mode, press any touchpad. A double
beep will sound.
To restore
the Clock display:
Press and hold the CANCEL and Clock pads for three sec-
onds. The time of day will reappear in the display.
The timer can be set from one minute @0:01} up to 99 hours
and 59 seconds _99:59}.
The timer can be used independently of any other oven
activity'. It can also be set while another oven function is
operating.
The Timer does not control the oven. It only controls a
beeper.
TO set the Timer:
1. Press the Timer pad.
, 00:00 and TIMER icon flash in the display.
2. Press the appropriate number pads until the correct time
appears in the display.
, The colon and TIMER icon will continue to flash.
3. Press Timer pad again or wait four seconds.
, The colon stops flashing and the time begins counting
down.
, The last minute of the timer countdown wiii be displayed
in seconds.
4. At the end of the set time, one long beep wiii sound and
"End" will be displayed.
5. Press the Timer pad to clear the display.
..............,
TIMER
To cancel theTimer:
,
! ...........
1. Press and hold the Timer pad for three seconds ..........
i
0
OR
2. Press the Timer pad and press '0' using the number pads.
Locking the Control
and Oven Door
The touchpad and oven door call be locked for safety,
cleaning, or to prevent unwanted use. The touchpads will not
function when locked.
If the oven is currently in use, the touchpads and door cannot
be locked.
The current time of day wiii remain in the display when the
touchpads and door are locked.
To lock:
(CANCEL}
1. Press and hold the CANCEL and Cook & Hold
.........
pads for three seconds .............
Cook &
° OFF appears in the display
° The LOCK icon flashes while the door is locking.
To unlock:
Press and hold the CANCEL and Cook & Hold pads for three
seconds. OFF disappears from the display.
Note: The touchpads and oven door cannot be locked if
the oven temperature is 400° F or above.
Fault Codes
The BAKE or LOCK icon may flash rapidly in the display to
alert you if there is an error or a problem. If the BAKE or
LOCK icon flashes in the display, press CANCEL pad. If the
BAKE or LOCK icon continues to flash, disconnect power to
the appliance. Wait a few minutes, and then reconnect
power. If the icon flashing still continues, disconnect power to
the appliance and call an authorized servicer.
5
Advertisement
