Inglis IJU58663 Use & Care Manual page 23

Savin
• Wash full loads. Running a half-filled
dishwasher uses the same amount of
electricity and hot water as a fully loaded
machine.
• Load correctly for best washing results.
Incorrect loading may cause poor washing
and the need to rewash all or part of load.
nergy
,, Do not prerinse normally soiled dishes.
Select the correct cycle for the load
and use the recommended amount of
detergent.
,, Use the Low Energy cycle whenever
possible. The cycle uses less hot water
and energy than the Normal wash cycle.
,, Use the Delay Hours feature to run your
dishwasher during off-peak hours. Local
utilities recommend avoiding heavy usage of
energy at certain times of day.
,, Use the Air Dry option whenever possible.
Allow longer drying times (overnight). Use
a rinse agent to improve drying.
,, Do not use SCOUR PLUS* or High Temp
Wash if it is not needed.
,, Loads may not wash or dry as well if the
water temperature is too low. For best
dishwashing results, water must be at least
120°F (49°C) as it enters the dishwasher.
To check water temperature:
1. Run the hot water at the faucet closest to
your dishwasher. Let the water
run for at least 1 minute.
2. Hold a candy or meat thermometer in the
running stream of water. {f the
water temperature at the faucet
is below 120°F (49°C), have a
qualified person raise the water
heater's thermostat setting.
23