Advertisement
SERVICE AND ADJUSTMENTS
TO REPLACE
MOWER
BLADE
DRIVE BELT
(See Fig, 26)
The mower blade drive belt may be replaced without tools.
Park the tractor on level surface. Engage parking brake.
BELT REMOVAL-
Remove mower from tractor
(See "TO REMOVE
MOWER" in this section of manual).
Work belt off both mandrel pulleys and idler pulleys.
Pull belt away from mower.
BELT INSTALLATION -
Work belt around both mandrel pulleys and idler pulleys.
Make sure belt is in all pulley grooves and inside all
belt guides.
Install mower (See "To Install Mower" in this section of
manual).
BELT INSTALLATION -
Install new belt from tractor rear to front, over the steer-
ing plate (F) and above clutch brake pedal shaft (G).
Pull belt toward front of tractor and roll belt onto engine
pulley (E).
Pull belt toward rear of tractor. Carefully work belt down
around transmission
cooling fan and onto the input
pulley (D). Be sure belt is inside the belt keeper.
Install belt on centerspan idler (C).
Install belt through stationary idler (A) and clutching
idler (B).
Make sure belt is in all pulley grooves and inside all
belt guides and keepers.
Install mower (See "TO INSTALL MOWER" in this sec-
tion of manual).
MANDREL
PULLEY
Fig. 26
TO REPLACE
MOTION
DRIVE BELT
(See
Fig. 27)
Park the tractor on level surface. Engage parking brake.
For assistance, there is a belt installation guide decal on
bottom side of left footrest.
BELT REMOVAL-
Remove mower (See "TO REMOVE MOWER" in this
section of manual).
NOTE: Observe entire motion drive belt and position of all
belt guides and keepers.
Remove belt from stationary idler (A) and clutching
idler (B).
Remove belt from centerspan idler (C).
Pull belt slack toward rear of tractor. Carefully remove
belt upwards from transmission input pulley and over
cooling fan blades (D).
Remove belt downward from engine pulley (E).
Slide belt toward rear of tractor, off the steering plate
(F) and remove from tractor.
J_
'i
ii
Fig. 27
21
Advertisement
