GE RGB740 Owner's Manual & Installation Instructions page 46

,O
,O
,O
,O
iii;;i!!!iii_i!iiiiiiiiii:i:_i
iiiiHl! iiiii
m
Before you call for service...
Troubleshooting -tips
Excessive smoking
Possible Causes
F_xcessive soil.
What To Do
• On m(>dels xdth touch pads, t(>uch tile CLEAR/OFF pad.
On models with an OVEN TEMP knob, turn it to OFF.
Open the windows to ridthe room of smoke. _4'ait until
the SELF CLEANlight goes off. Wipe tq) the excess soil
and reset the clean cycle.
Oven door willnotopen Oven too hot. • _Mlow the oven to cool beh)w h)cking temperature.
after a clean cycle
Oven not clean after Oven conU'ols not properly set. • See the Using the self-cleaning oven section.
a clean cycle
Oven was heavily soiled. • (3eau tq) heavv s )illove_s heft)re st_u'tiug the (leau cycle.
Heavily soiled ovens ma_ need to sell:clean again or for
a h)uger period of time.
Oveu door will not Oven is too hot. • ?dh)w the ()yen t() c()()l below h)ckiug temperature.
unlock (on models Do not lock the door with the door latch except wheu
with a doorlatch) usiu(_ the sell:cleau tFattu'e.
Self clean light (on The OVEN TEMP knob has not • Set the OVEN TEMP knob to CLEAN. See the Using the
some models) blinks
been
set to CLEAN when
the
self-cleaning oven se('tiou.
when trying to set a latch was moved to the right.
self clean cycle
The latch was not moved to the • M(>ve the latch t(> the right as Lu" as it will _ q> See the
right when the OVEN TEMP knob Using the self-cleaning oven secti(>u.
was set to CLEAN.
Self clean light (en A power interruption occurred. •Turn tl_e OVENTEMPkuob to OFFaud move the latch
some models) blinks to the left as Lu" as it will go. Reset the range controls
during self clean cycle
to the desired settings.
See the Using the self-cleaning
oven sectiou.
"Door"appears in the Self-clemlh_g cycle has been • Move the latch handle all the wa_ to the right.
display (on some models_ selected but the latch handle
was not moved all the way
to the right.
Latch hmzdle was moved to the
right but a progrmn other thml
self-clemlhzg was selected.
• Move the latch handle to the right onl) when ,setfino
the sell:(leaning (y(le.
"F--and a number or On models with a door latch, • The latch may have been re(wed, even if only slightly,
letter"flash in the display if a function error code appears fl'(>m the h>cked p(>sitiou. Make sure the latch is m(>ved
ton some models/ during the self-clemmlg cycle, to the right as far as it will go.
check the oven door latch.
You have a function error code. • Touch the CLEAR/OFFpad. ?dlow the oven to cool fbr
one hour: Put the oven back into operation.
If the function code repeats. • Discom_ect all power to the range fi)r 5 minutes
and then recom_ect l)owe_:/f the flmctiou error
code repeats, call tbr service.
46