GE RGB740 Owner's Manual & Installation Instructions page 12

Usingthe oven.
Toavoid possible bums, place the shelves in the desired position before you turn the oven on.
Before you begin...
Tile shelves have stoic-locks, so that when
I)laced correctly on tile shelf supports
(A through E), they will stop befin'e
c()ming completely out, and will not tilt,
\,\]/en
placing
and removing cookware,
pull tile shelf out to tile bum l) on tile
shelf' SUl)po_t.
Toremove a shelf, pull it toward you, tilt tile
ti'ont end up and pull it out.
TOreplace, l)lace the end ot the shelf
(stopqocks) on the sui)port, tilt up the
front and push the shelf in.
NOTE: Theshelf is not designed to slide out at the
specb/ low shelf (R)position.
The oven has 5 shelf positions.
It also has a special low shelf
position (R)for extra large items,
such as a large turkey.
Plastic items on the cooktop may
melt if left too close to the venL
Vent appearance and location var_
Oven Vent
Y()ur oven is vented through ducts at tile
rear of the range. Do not block these ducts
when cooking in the oven--it is important
that the flow of hot air fl'om the oven
and fl'esh air to tile oven burner be
tminterrul)ted. Avoid touching tile vent
openings or nea_q_y stu_hces (lurhlg oven or
broiler operation--they may become hot.
::J_:: Handles ofpotsandpanson thecooktop may
become hot if left toodose to theven_
::Ji:: Donot leave plastic or flammable items on the
cooktop--they may melt or ignite if left too close
to the venL
_: Donot/eavec/osed conta/eers o n thecooktop.
The pressure in c/osed conta/eers m ayincrease,
whichmaycause themto burs_
_: Metalitemswi//become very hot if theyare left
on thecooktop, a ndcouldcause burns.
Power Outage
.4,CAUTION: Donotmakeany
attempt to operate the electric ignition oven
during
an e/ectnca/ power failure.
Tile oven or broiler cannot be lit dtuing
a power fifilm'e. Gas will not flow unless
the glow bar is hot.
If tile oven is in use when a power fifihu'e
occ/li'S_ tile
oven b/lI'neI"
shtlts off and
cannot be re-lit until power is restored. This
is because tile flow ot gas is automatically
stopped and will not resume when power
is restored until tile glow bar has reached
operating temperature.
Oven Light (onsome models)
Touch tile OVENUGHTor -_'_ pad on tile
ul)per control panel to turn tile light on
of o JilL'.
Oven Light
(on some models)
Press tile OVENLIGHTpad on,, tile lower
control panel to turn the light on or off.
12