GE RN328 Owner's Manual And Installation Instructions page 13

Installation Instructions
II_ SCREW IN PARTWAY
Drixe a mounting screw (front the hardware packet)
partway into each center of the narrow neck of the
keyhole slots marked on the cabinet bottom.
[] OPTIONAL POWER CORD
KIT JXHC1
An optional Power Cord Connection Kit, model
JXHCI, is awfilable at extra cost fl'oln vour GE
supplier
fro" installation
using a standard 3-prong,
grotmded wall outlet. Follow the Installation
Instructions packed with the kit to connect the
power cord to the range hood.
Cabinet
3-prong
{if usingcord
connection)
lYg' dia. clearancehole
for optional power
supply location
NOTE: If using optional Power Cord ICdtJXHCI,
feed the power cord through the hole in the top
cabinet while raising the hood. I,oop any excess
length of cord and tie awav with a suitable tape
or tie.
1_] FEED IN WIRES
I,ifl the hood into position and feed the house
wiring through the wiring knockout.
[] SECURE HOOD
Slide the hood back against the wall. Tighten
the motmting screws. Be sm'e the screw heads
are in the narrow neck of the keyhole slot.
Keyhole(4)
\
NOTE: DO NOT PUSH ON FAN BI,ADE. Pushing
on the blade may cause it to interfere with other
hood parts.
[] CONNECT DUCTWORK TO
HOOD
(Ducted installations only)
On 7" rotmd installations, attach the 7" duct
with sheet metal screws throuoh the holes in
the aligmnent ears,
-<---- 7" round duct
Use duct tape to make joints secure and air ti *ht
13