Table of Contents
Advertisement
P_5.1
Handle
positions
The handle of your cleaner has three
positions; upright for storage and when
using cleaning tools; operating posi-
tion for general operation on carpet
and floors; low for reaching under low
furniture. Step on handle release lever
to lower handle.
Transporting
cleaner
Put handle in upright position. Tilt
cleaner back on rear wheels. Push
forward.
Carrying
handle
Use the carrying
handle to lift the
cleaner.
P_]
B
C
D
.,Q. _
|
|
|
J BAR_ FLOOR
Carpet
height
adjustment
The cleaning of carpet and rugs takes
place at the nozzle (A).
When it is necessary to raise and lower the
nozzle for various carpet pile heights, slide
the nozzle control knob (B) to the desired
setting.
Handle
position
For ease in sliding knob, place handle
in the upright position (C).
The nozzle will not move into the
adjusted position until the cleaner
handle is lowered to the operating
position (D).
Settings
For maximum cleaning performance,
the following carpet height settings are
recommended.
• Lowest setting: for all types of carpet
and hard floors.
Note: If the cleaner is difficult to push,
slide knob to the next higher setting.
• Higher settings: for very deep pile
carpet where easier pushing effort is
desired, while maintaining good cleaning
performance.
Advertisement
Table of Contents
