Table of Contents
Advertisement
,
Tap the other axle cap onto the opposite end of
the axle and place the axle assembly onto the
bottom of the charger. Place one end of the
bracket into slot, then place the axle assembly
under each bracket. Fasten the other side of the
brackets using the two 10-32 screws provided.
To attach
the handle:
Turn the charger right side up onto its foot and wheels.
Remove the two top screws from each side of the
charger and align with the screw holes on the handle.
Attach the handle using the same screws.
Plugging
it in
Electrical Shock Hazard
Be sure that power cord fits propedy into outlet.
If not, have a qualified technician install a proper
outlet. Never alter the AC cord or plug provided,
Improper connection can result in electrical shock,
Your charger should be grounded to reduce the
rlak of electrical shock.
Your charger is equipped with an electrical cord that
has an equipment grounding conductor and a ground-
ing plug designed to be used on a 120 volt circuit. The
plug must be plugged into an outlet that has been
properly installed and grounded in accordance with all
local codes and ordinances.
Hide quick links:
Advertisement
Table of Contents
