Table of Contents
Advertisement
Generac Portable P roducts 3,500 WattGenerator
INSTALL WHEEL
KIT
IMPORTANT:
This wheel kit is not intended for
over-the-road use.
To installyour wheel kit you need the following tools:
• Two 13mm box, open end, or socket wrenches
Install Wheel Kit as follows:
• Placethe bottom of the generator cradle on a fiat, even
surface. Temporarily place unit on blocks to ease
assembly.
• Slide axle through both axle mounting brackets on cradle
frame, as shown.
• Slide a wheel over the axle.
NOTE: Be sure to installboth wheelswith the air
pressure valveon the outboard side.
• Retain wheel on axle with the retaining pin.. You may acid
the fiat washer if desired.
• Repeat step 3 and 4 to secure second wheel.
• Remove the existing hardware from the vibration mounts
with 13mm wrench. Use the same hardware to attach
the mounting leg.
• Remove the temporary blocks.
• Center the handle bracket on generator frame at control
panel end of cradle.
• Attach handle bracket with two cap screws and two hex
nuts. Use two 13 mm wrenches to tighten hardware.
___I T4_
I'_¢r,',',',',','_I
IIkvA"rA
IT'_L'4
] 114g
Handle
Assembly
\
\
\
\
Flat Washer
Mounting Leg
J
Use Existing Fasteners
/
Jam Nut
/
Wheel
/
Retaining Pin
/
5
Advertisement
Table of Contents
